Comparable to International brands. Meet all international standards including ASTM & Lo-Voc.
ISO Certified.
Each batch tested & test reports available.
Products are usually shipped within 2 days of ordering.
One stop for all your requirements.
Dedicated customer service executives that attend to all your needs & queries.
Strong tech support.
• For copper tube size (CTS) CPVC hot and cold potable water pipe and fittings up to 4” diameter interference fit.
• Medium Bodied, Fast Setting.
• Lo-V.O.C. Solvent Cement meets ASTM-493 & D-2846
• For Hot water upto 82°C (180°F)
1. Cut pipe square and deburr or bevel 10-15°. Clean and dry
joining surfaces.
2. Check dry fit. Fitting should go over end of pipe easily but become tight about 1/3
to 2/3 of the way on.
3. Apply a full, even layer of solvent on the pipe end up to socket depth; coat
the fitting socket with a light layer (avoid excess & puddling). Solvent should fill all gaps.
4.
Assemble quickly while solvent is wet. Twist 1/8 to 1/4 turn until reaching pipe stop. To avoid push
out, hold for 10-30 seconds.
5. Allow 10 mins for good handling strength and 1 hr cure time for cold water systems up to 160 psi (11.3 kg/cm2) and 6 hours for hot water systems
100 psi (7.0 kg/cm2) maximum, 180°F (82°C).
• For up to 4" (100mm) UPVC/PVC pipe
• Medium Bodied, Fast Setting.
• Lo-V.O.C. Solvent Cement meets ASTM-2564
• High Strength Formula
1. Cut pipe square and deburr or bevel 10-15°. Clean and dry
joining surfaces.
2. Check dry fit. Fitting should go over end of pipe easily but become tight about 1/3
to 2/3 of the way on.
3. Apply a full, even layer of solvent on the pipe end up to socket depth; coat
the fitting socket with a light layer (avoid excess & puddling). Solvent should fill all gaps.
4.
Assemble quickly while solvent is wet. Twist 1/8 to 1/4 turn until reaching pipe stop. To avoid push
out, hold for 10-30 seconds.
5. Allow 10 mins for good handling strength and 1 hr cure time for cold water systems up to 160 psi (11.3 kg/cm2) and 6 hours for hot water systems
100 psi (7.0 kg/cm2) maximum, 180°F (82°C).
• For use on all schedules & classes PVC pipe & fitting up to 6” dia.
• Regular Body, Slow Setting.
• Recommended for SWR, Drainage Conduit & DWV for pipes with interference fit. Also for PVC doors & Windows
1. Cut pipe square and deburr or bevel 10-15°. Clean and dry
joining surfaces.
2. Check dry fit. Fitting should go over end of pipe easily but become tight about 1/3 to 2/3 of the way on.
3. Apply a full, even layer of solvent on the pipe end up to socket depth; coat the fitting socket with a light layer (avoid excess & puddling). Solvent should fill all gaps.
4. Assemble quickly while solvent is wet. Twist 1/8 to 1/4 turn until reaching pipe stop. To avoid push out, hold for 10-30 seconds.
5. Allow 10 mins for good handling strength.
*We dont share your personal info with anyone. Check out our privacy policy for more information.
How to develop a free website - Go here